Royal Gas Heater for Commercial Greenhouses, Auto Shops, and Farm Buildings

The horizontal section of pipe should never run longer in feet
than 1/2 the height of the vertical chimney section.

Jet/Vortex combustion design	Easy - out burner service tray
Draft Diverter included	Horizontally directed air flow pattern
Jets easily cleaned-no plugging	Draft in the chimney should never be less than 0.2 to 0.4 inches
Stainless Steel Baffling	Always check with the gas company on appropriate gas supply pipe sizing
10 year warranty* on heat exchanger	Always vent gas fumes, as unvented gas fumes can cause death to plants, animals and humans
Fully shielded blower assembly Summer fan switch	Draft diverter must always be attached to the furnace VERTICALLY unless otherwise stated by Siebring Mfg. WARRANTY WILL BE VOID if venting does not meet local codes for gas venting
Blower motor Model 125 - 3/4 HP RH 240 - 3/4 HP RH 360 - 1 HP 10 year warranty *Warranty void if unit is used without proper burner installation and control bonnet and chimney.	Exhaust fans in greenhouses or warehouses should not run while furnaces are operating The chimney from the furnace to the draft cap should not be reduced in size Always use double wall chimney pipe on gas units Use black iron gas pipe on natural gas units Never use with line voltage thermostat

MODEL 240 - 240,000 BTU	MODEL 360 - 360,000 BTU
Case Width 27"	Case Width 31"
Overall Width (gas valve incl) 31"	Overall Width (gas valve incl) 35"
Case Length 27"	Case Length 31"
Overall Length 48"	Overall Length 54"
Case Height 48"	Case Height 48"
Overall Height 51"	Overall Height 51"
Weight 640 lbs.	Weight 780 lbs.
Blower Sizes 3000 CFM	Blower Sizes 3500 CFM
Horsepower (Blower Motor) 3/4 HP	Horsepower (Blower Motor) 1 HP
Amps (Blower Motor) 7 AMP	Amps (Blower Motor) 9.0 AMP
Chimney 8"	Chimney 9"

Number of Openings and Opening sizes (choose one)
Round: 3 - 12" Openings or 4 - 12" Openings

WARRANTY (Parts Only)

Every furnace is guaranteed against defective parts, materials
and workmanship for ONE YEAR from date of purchase. Warranty void if
heat exchanger is damaged by explosion caused by over firing or improper
installation. Heat Exchanger replaced on a 10 year prorated basis.

Defective parts must be returned prepaid to SIEBRING MFG. INC.
for warranty replacement. No service, labor or shipping implied
in this warranty.

Guarantee Registration Card shipped with unit must be returned to factory
for issuance of the Standard Service Adjustment Warranty.
NOTICE
In the event of failure of this product, SIEBRING MANUFACTURING, INC.
accepts no responsibility other than for its own products; and accepts no
responsibility for damage to environment, crops etc. Warranty is void if
manufacturer's specifications are not followed in installation.